5 Laws Everybody In Peugeot 308 Key Fob Should Be Aware Of

Peugeot 308 Key Fob replacement peugeot key fob

Peugeot's 308 may be catching on a bit, but it still feels appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 407 key 308 key fobs. Whether the problem is persistent or intermittent these tips will aid.

Water Damage

If you accidentally drop your key fob in a puddle, or if it is soaked while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to excessive water.

You should also make sure that the fob is completely dry before opening it up and re-using it. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid), this is another sign that it has been submerged.

A wet circuit may cause the battery's power to be depleted or even explode. If you're able fish your key fob 308 out from the body of water it got stuck in it, flip the button side down and shake it out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board down with a cotton swab that is dipped in 90 percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could be unable to function could be due to an empty coin battery or receiver module issues, signal interference, or an electronic chip that is damaged. If none of the above is the cause you can reset the system by removing the 12 volt battery from the vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start that allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car prior to entering. This feature is very useful particularly in cold winter months. The remote start system may stop working for a variety reasons, including the dead battery in the coin-battery.

A coin-shaped battery found inside the key fob can last for a period of between two and four years, depending on how often it's used and where it's purchased. The date for use-by is typically found on the packaging or listed in the instruction manual.

If the key fob has stopped working after exposure to water that is clean, you should take the battery off, clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. In the event of exposure to soapy or salty water, the chip could be damaged and you'll require replacing the key fob completely.

If you're unsure whether the battery is in good condition, you can check its voltage with a multimeter attached to both the minus and plus terminals. The voltage should be between 12 to 13 volts, but if it's lower, the battery must be replaced. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now start.

Faulty Receiver Module

If you aren't seeing the "Key Detected" message, it could mean the receiver module malfunctioning. It's the component which sends out an alert when your key fob goes off. It also acts as an alarm, and stops the vehicle from starting without the correct key.

This could be due to a number of causes including water damage or simply ageing. If your Peugeot 308 key fob has been exposed to dirty tap water, as in, the electronic chip inside the device will be damaged. In this scenario you'll need to remove the unit apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the problem persists, it's probably a good option to consult an area Peugeot specialist or locksmith. They can use a diagnostic tool in order to identify the issue and repair it.

Losing your Peugeot keys to your car can be an extremely stressful experience. However, a professional auto locksmith can solve the issue in only a few minutes. They can program your vehicle and cut a new, functioning key for you. Click here to find a locksmith near you.

Electronic chip that is malfunctioning

The electronic chip in your peugeot 2008 key (click the next website) 308 key fob is a very crucial component of the remote control system. If it is damaged your car may not start or you might receive a message that reads "anti-theft active". In this instance the only option is to replace the key. Luckily, auto locksmiths who are professionals can offer the service in the shortest time.

The chip inside your peugeot 5008 key 308 key fob can fail due to water damage, sweat dirt, or other causes. If your Peugeot key fob has been exposed dirty or soapy water, it must be cleaned right away. You can make use of a towel and isopropyl alcohol to wipe the electronic component. After that, you should let the battery completely dry.

Radio interference can cause a key fob to stop functioning. This can be caused by other devices operating at the same frequency as your Peugeot key fob. This can be caused by problems with the environment or objects in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this issue.

The Peugeot Key Fob 207/308 is fragile and requires special care. It is essential not to throw or drop the key fob. If you lose it, try to find it as quickly as is possible. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable before the positive.